Catalogue Parameter Verification Notes

Reviewed 18 October 2026. These notes distinguish statements supported by the existing catalogue from values that still require a current TONZO specification.

What the reference files establish

Equipment	Review result	Selection note	Catalogue page
PEX jaw crushers	Feed opening and strength – pending	Two model rows conflict with the catalogue model names. External PEX tables support a likely source error, but cannot establish TONZO dimensions. The CSV retains To confirm for PEX250×1000 and PEX300×1300. The source also conflicts on maximum compressive strength: 350 MPa in Chinese and 320 MPa in English. Neither is adopted as an approved limit.	4
PF impact crushers	Specification – meaning pending	The original column is retained. Other PF manufacturers label similar dimensions as rotor diameter × width, but TONZO requires a drawing or written clarification before using these values as rotor or installation dimensions.	5
HP cone crushers	Discharge-opening label clarified	The source Chinese heading refers to the minimum discharge opening. This is not a guarantee that every output particle is below that size. Confirm the cavity and operating setting for the feed.	7
YKJ vibrating screens	Feed-size label clarified	The original heading refers to maximum feed particle size. Screen-surface dimensions describe the deck; they do not specify mesh opening, screen media or guaranteed screening efficiency.	25
WS / 2WS fines recovery	Units and power boundary confirmed	The table gives reference water-handling capacity in m³/h and vibration-motor power in kW. It does not provide recovered dry solids in t/h or total system power. The source states that the pump is selected separately.	28
HHT filter presses	Throughput and moisture – pending	The HHT200-1250A throughput cell appears as a date (7月10日). The source text states moisture below 30%, while its table lists 60-68%. No numerical replacement is inferred. The CSV marks the affected throughput and moisture values To confirm. Listed plate-shifting time is not established as a complete filtration-cycle time.	30
SHY integrated washing	Feed-size label clarified	The source footnote identifies Selected granularity as feed particle size. Listed water flow is not a fresh-water consumption guarantee. Pumps, pipework and other supply boundaries must be checked in the quotation.	31
TS dewatering screens	Screen-area unit – pending	The source English unit for screen area is inconsistent. Do not use the printed unit to calculate area or equipment capacity. Confirm the dimension and unit from a current drawing or revised data sheet.	32

How to use the files

The downloadable catalogue and CSVs retain the existing reference edition. The notes above accompany that edition; they are not a new factory-approved data sheet. Current model availability, final dimensions, settings, performance and supply scope require a project-specific written proposal.

Specifications from another manufacturer can clarify terminology and reveal a discrepancy. They are not replacements for the corresponding TONZO model values.

Open the catalogue and reference tables, or send the model and duty for clarification.

Sources and review scope

The supplied corrected catalogue and the published Chinese-English edition were compared on the relevant equipment pages. The complete catalogue has not been certified or comprehensively re-engineered in this review.